Light Kit Assembly (Optional) - Craftmade Bellows II Guia De Instalacion

8. Light Kit Assembly (Optional).

If you wish to USE the light kit, remove 1 screw
from motor plate on underside of motor
assembly and partially loosen the other 2 screws.
Align slotted holes in large fitter plate with
loosened screws in motor plate, allowing molex
connections from motor assembly to come
through hole in middle of large fitter plate. Twist
large fitter plate to lock. Re-insert screw
previously removed and securely tighten all 3
screws with a Phillips screwdriver.
Remove 1 screw from post on underside of large
fitter plate and partially loosen the other 2
screws.
Connect WHITE wire from motor assembly to
WHITE wire from light kit fitter. Connect BLACK
(or BLUE) wire from motor assembly to BLACK
wire from light kit fitter. Be sure molex
connections snap together securely.
Align slotted holes in light kit fitter with
loosened screws in large fitter plate. Twist light
kit fitter to lock. Re-insert screw that was
previously removed. Tighten all 3 screws
securely.
Install 2 medium base 9-watt LED bulbs
(included).
Important: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching.
Remove finial and finial plate from threaded
rod at bottom of light kit fitter.
shade in order to align threaded rod on light
kit fitter with hole in middle of glass shade
and push up gently, allowing threaded rod to
come through hole. Replace finial plate and
finial that were previously removed. Secure
glass shade to light kit fitter by tightening
finial.
NOTE: Do NOT overtighten finial as glass may
crack or break.
Raise glass
threaded rod
page 7
post
light kit
fitter
finial
motor
assembly
motor plate
large fitter plate
molex connections
motor assembly
large
fitter plate
molex connections
light kit fitter
bulb
motor assembly
glass shade
finial plate