Attaching And Removing The Computer Stand - Dell OptiPlex 170L Guía De Referencia Rápida

Attaching and Removing the Computer Stand

CAUTION:
section, follow the safety instructions in the Product
Information Guide.
NOTE:
Place your computer on a soft surface to prevent
scratching the top cover.
Your computer can be used in either a vertical or
horizontal position.
To use the computer in a vertical position, you must
attach the computer stand:
1
Place the computer on its right side so that the drive
bays are at the bottom and fit the stand onto what
was the left side of the computer:
Position the stand as shown in the following
a
figure by aligning the large round hole in the
stand with the securing button on the side of the
cover.
Align the captive screw in the stand with the
b
screw hole in the cover, and tighten the
thumbscrew.
2
Rotate the computer so that the stand is at the
bottom and the drives are at the top.
10
Quick Reference Guide
Before you begin any of the procedures in this