Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the 2 pairs of hook and loop fasteners and
4 pairs of snaps on the rain cover.
24 25
!
Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant child restraint has been fastened.
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
If the rain cover is on the stroller, always remove rain cover to prevent ripping and tearing.
!
Do not place your child into the stroller assembled with rain cover during hot weather.
!
When using your stroller at the beach, completely clean your stroller after use to remove sand and salt from
mechanisms and wheel assemblies.
Use Footmuff
The soft footmuff can provide your child with a warm and comfortable environment.
Assemble the footmuff by following these steps.
1. Place the footmuff over the seat after unzipping it, thread the shoulder harnesses, waist harnesses and
crotch harness through respective slots.
2. Thread loop fastener on the top of the footmuff through the backrest, and then stick it to the hook
fastener.
28
3. Place baby into the footmuff, lock the safety buckle, and then rezip the footmuff. The assembled
footmuff is shown as
29
.
For the using method for restraint system and armbar, please refer to the relevant section in the
!
instruction manual.
Care and Maintenance
!
Removable seat pad may be washed in cold water and drip-dried. No bleach.
!
To clean stroller frame, use only household soap and warm water. No bleach or detergent.
!
From time to time, check your stroller for loose screws, worn parts, torn material or stitching. Replace or
repair the parts as needed.
!
Excessive exposure to sun or heat could cause fading or warping of parts.
!
If stroller becomes wet, open hood and allow to dry thoroughly before storing.
!
If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get
1
the oil into the axle and wheel assembly.
13
26
27
14