Abicor Binzel MT Instructivo De Servicio página 32

6 Putting into operation
6.2.2 PA liner
1
10
9
1 Wire feed hose
2 Central plug
3 Union nut
4
Wire feed unit
Fig. 4 Shortening the PA liner
EN - 12
PA liners = for aluminium, copper, nickel and stainless steels
2
40 °
8
5 ABICOR BINZEL
6 Guide tube
7 O-ring
1 Sharpen the beginning of the PA liner (9) to approx. 40° with the
ABICOR BINZEL sharpener (10).
2 Slide PA liner (9) through the wire feed hose (1) until a noticeable
resistance is felt in the contact tip.
3 Slide clamp nipple (8), O-ring (8) and union nut (3) on the PA liner (9) and
tighten the union nut (3) under tension.
4 Mark a PA liner (9) that is too long in front of the wire feed rollers.
5 Cut the PA liner (9) at the mark with the ABICOR BINZEL cutter (5) .
6 Sharpen the cutting point.
NOTE
• For PA liners of outer diameter 4.00 mm, the capillary tube in the
intermediate joining section must be replaced by a guide tube.
3
7 6
Cutter
8
9
10 ABICOR BINZEL
MT/AUT/AUT RAB
4
5
Clamp nipple
PA liner
Sharpener