Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2
Figure 2
1/2" Maximum
Figure 3
Use Optional Spacer if
Needed
Alignment Arrows
Figure 4
Helpful Videos – www.hzsupport.com
2. Remove orange battery tab from sensor.
Remove back of case by pushing in tab on
bottom with a small screwdriver (see Figure
2). Remove orange battery tab.
3. Test range. Before mounting, hold sensor and
magnet in selected location and verify opera-
tion. While holding the sensor still, move the
magnet away from the sensor to simulate door
being opened. Verify red LED on sensor flashes
momentarily and chime sounds. Note: If sensor
does not operate correctly, see Troubleshooting.
4. Adjust volume control. Unplug chime and
adjust volume control to desired volume (see
Figure 1). Plug chime back into wall outlet.
5. Mount sensor. Use either screws or
double sided tape to mount push button.
IMPORTANT: The maximum gap between
sensor and magnet is 1/2" (13 mm) (see
Figure 3). The arrows located on the face of
each component must be aligned and facing
toward each other (see Figure 4). The magnet
must be beside the sensor. Note: If the magnet
is recessed, use spacer to ensure proper
alignment (see Figure 4).
Helpful Answers – 1-800-858-8501
Publicidad
Tabla de contenido
