MOWOOT PS 4075 P-B Manual De Instrucciones página 46

opened - fig. 7c).
4. Move the fuel valve lever to "ON"
5. Set the gear activation lever to transport position to prevent cutter deck from touching
the ground (fig. 7d).
6. Standing behind the unit, pull and hold the brake control handle (fig. 7e).
7. Pull out the rope starter handle (as shown in fig. 7e) slowly until you feel some re-
sistance. Then wind it fully out rapidly. Return it slowly to the rope guide pin after the
engine has started. Keep the brake control handle pulled all the time. Release it to stop
the engine immediately.
8. Move the gear activation lever from the transport position to the operating position to
engage the cutter roller (fig. 7f).
9. Guide the unit in parallel paths.
Note! If the cutter deck is in contact with the ground, the unit will move.
Fig. 7a
Choke lever
Fuel valve lever
Fig. 7c
17
(fig. 7c)
Choke lever
Fig. 7b
Fig. 7d
Clutch
disengaged
(EN)