Kohler STERLING 6300 Serie Guia De Instalacion página 10

Bulb Seal
Wall Jamb
Strike Jamb
10. Install the Door Panel
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
floors or other hard surfaces or it may shatter.
Slide the hinge jamb into the other wall jamb. Each slot in the hinge jamb will slide over the screw
body and fit between the clamp and wall jamb.
Tighten the four flathead screws, using the 3/32" hex wrench, until snug.
11. Adjust and Secure the Door
The glass edge should be aligned evenly 3/16" (5 mm) from the strike jamb.
Adjust the door by loosening the jamb screws and shifting the assembly (maximum adjustment is
3/4" (2 cm) on each side) as needed.
1019156-2-F
Adjust the top edge of
the door glass to be
even with the top edge
of the bulb seal.
Wall Jamb
Strike Jamb Latch
Glass
Bulb Seal
3/16"
(5 mm)
Glass
Top View
Hinge Jamb
10
Hinge Jamb
Flathead Wall Jamb
Screw
Clamp
Wall Jamb
Sterling