Kohler STERLING 6300 Serie Guia De Instalacion página 6

Wall Jamb
4. Install the Wall Jambs
With a pencil, mark the location of the wall jamb on the shower wall. Measure evenly on both sides.
Place the wall jamb against the wall and check for plumb with a level. The adjustment clamps will
be located closer to the inside of the shower.
Make a pencil mark at each of the four pre-drilled holes in the wall jamb and remove the wall jamb.
Lightly center punch the four hole locations on each wall.
When the installation is on ceramic tile, use the center punch to nick the surface glaze. Tap the
punch lightly with the hammer to avoid cracking the ceramic tile.
Drill each hole with a 3/16" drill bit (use a masonry bit for ceramic tile), and insert anchors in each
hole.
Secure a wall jamb in place using four #8-18 x 2" panhead screws.
Repeat the procedures for the other wall jamb.
Remove the bottom track and thoroughly clean the shower ledge.
5. Caulk and Install Bottom Track
Insert the bottom track and check for proper fit. The lip of the bottom track should face toward the
outside of the shower. The ends of the bottom track should fit snugly against the front protrusions
in the wall jambs.
Remove the bottom track and apply silicone sealant in the groove at the bottom front edge of the
bottom track.
Install the bottom track.
1019156-2-F
Drill holes
Anchor
#8-18 x 2"
Panhead
Screw
6
Apply sealant
here.
Wall
Wall
Jamb
Jamb
Top View
Bottom Track
Bottom
Track
Sterling