Removing Your Mask - Roscoe Medical DreamEasy 2 Manual Del Usuario

6. Lie down and readjust the straps if needed.
7. Connect your PAP device's air tubing to the rotating
elbow on the front of the mask. Ensure the other end
of the tubing is attached to the device. Turn on your
PAP device and use as directed by your physician.

REMOVING YOUR MASK

1. Unhook one or both of the lower headgear clips from
the mask shell.
2. Gently pull the mask up and away from your face going
over your head.
CLEANING YOUR MASK AND HEADGEAR
Both the mask shell and headgear should be hand washed
with a mild soap and warm water. The seals can also be
cleaned with an alcohol-free mask wipe to remove excess
DO NOT
facial oils.
clean your mask. Ensure that all components are thoroughly
rinsed and air dried before using again.
mask in direct sunlight.
• It is recommended that the Comfort Cushion be replaced
regularly, as often as twice per month.
• It is recommended that the complete mask and headgear
are replaced every 3 – 6 months.
ONLY
• use Roscoe DreamEasy 2™ replacement parts.
* The forehead pad and Comfort Cushion
the mask frame is pushing into your face or forehead. There should be
wiggle room for movement.
2. Slip the headgear and mask over
your head and place the cushion over
your nose in a comfortable position.
NOTE:
your nostrils or breathing in any way.
If there is any obstruction, check the
cushion size and or mask position.
3. Re-hook the lower headgear clip.
The mask may feel loose on your
face.
4. To tighten, start with the top two (2)
straps. Using both hands, release the
hook and loop tabs on each side, of
the headgear. Gently pull the tabs
back until the top of the mask shell
conforms to your head. Reattach
the hook and loop tabs, ensuring
theyarefirmlyinplace.DO NOT
overtighten*.
5. Repeat with the bottom two (2)
straps. The Comfort Cushion should
conform to your facial contours.
DO NOT
use abrasive cleaners such as bleach to
The seal should not obstruct
overtighten*.
DO NOT
SHOULD NOT
™
store your
be so tight that
5