miniland baby digimonitor 8 plus Manual De Instrucciones página 34

Channel linking:
This product is designed to allow monitoring different areas with up to 4 cameras
(Channel 1, 2, 3 or 4 assigned to different cameras). The original monitor and
camera are already set on Channel 1 by manufacturer at factory. If you need to
add extra new camera for monitoring, you need to choose a new channel to 'link'
the new camera with existing monitor.
- Plug the USB receiver into the monitor (photo frame). Turn OFF the camera.
Place them not more than 2 feet apart.
- Choose your preferred channel by pressing Chanel selection button (3) in the
USB receiver. Press and hold on the Channel selection button until the red LED
starts blinking.
- Then turn ON the camera. Keep pushing the hidden Linking button (10) through
the small hole at the back of the camera by using a pin. The Power LED Light will
start flashing indicating the linking process; linking between the camera and the
monitor unit is undergoing.
- Linking is successful when your live image can be seen on the monitor screen.
At this moment the power LED on the Camera stops flashing and the camera
unit and the monitor unit work well together.
- Repeat the above process to connect additional cameras (up to 4 cameras).
Baby Monitor mode options:
A) Image size:
By default you will see the image from the
camera on the monitor on the full screen.
You can use see your baby with this attractive
frame, by pressing the Zoom key in the remote
control:
With this baby monitor you can connect up to 4 cameras to monitor different places
(please read "Channel linking" section).
Once you have the cameras connected, to see the image from the different
channels you have to press the channel selection button (3) in the USB receiver,
the LED corresponding to the selected channel will be on, and the monitor will
show the image from the selected camera.
34
English