Gima ECG 300G Manual De Instrucciones página 110

Chest 3
Chest 4
Chest 5
Chest 6
Note
Ø It is recommended to install the lead cables after turning off the device.
Ø Apply appropriate amount of conductive paste on the electrode when installing the
electrode.
Ø
If the ECG waveform does not appear for a long time, check if the electrode is in
good contact with the skin.
6.4.4 Lead method and system
As shown in Figure 6-5:
6.4.5 Lead-off and overload indication
The device can check the connection status of the lead at any time. If lead-off or overload is
detected, the screen will display corresponding lead code on the top left corner.
Note
Ø In the lead-off prompt area, red font represents lead-off, yellow font represent
overload.
Ø When the connection between lead cable and patient/the device is not reliable, and
the ECG signal can not correctly transmitted, the device displays lead-off.
C3 Green
C4 Brown
C5 Black
C6 Purple
Figure 6-5 Lead system
V3
V4
V5
V6
17
Green
Blue
Orange
Purple