Sampling Interface - Gima ECG 300G Manual De Instrucciones

to set the print mode, print style and print content, etc.
to view the information about our company, software version.

7.2 Sampling interface

Click on the main interface or press the
Note: There is input time of cases in the system setting, therefore, case information should
be input before formal sampling. (refer to 7.3 for details)
The sampling interface provides several lead display modes, including 3-lead, 6-lead and
12-lead. The following figure uses 12-lead as an example:
Instant Heart rate
Lead
End sampling: After the device starts sampling, use the
sampling, and back to the main interface.
Switch lead: When the device does not simultaneously display 12 leads, use the
buttons to switch displayed waveform.
Switch lead display style: use the
between 3-lead, 6-lead and 12-lead.
Lead-off information: In demo mode, it displays "DEMO ECG". In sampling mode, it
displays the detected lead status.
Print mode: use the
Auto 3×4+1, Auto 3×4, Auto 2×6+1, Auto 2×6, Auto 3-2+1, Auto 3-2, Rhythm 4, Rhythm 3 and
Lead-offinformation
Gain Speed Filter
button to switch the print mode between Manual, Auto 4×3,
button to enter the sampling interface.
Print mode
and buttons to switch the display style
19
Status
Instant
Waveform
button to end the
and