Leister WELDPLAST S6 Instrucciones De Funcionamiento página 23

Operation
Current supply
120
When using an extension cable, it must have a minimum cross-section of 3 x 4 mm
230
authorized for the utilization site (e.g., outdoors) and be marked accordingly.
When a power generator is used as an energy supply, the following applies for its nominal output:
2 × nominal output of the handheld extrusion welder.
FI
Start-up process
The temperature monitor prevents the handheld extrusion welder from starting when it is in a cold state.
Drive status
display (30)
setpoint values are reached
After switching on the main switch (1) press any key on the operating unit (32). The device then heats to the most
recently set target temperatures. When the target temperatures have been reached, a counter in the status
display counts back from 30 seconds to zero. After this start-up process, the device is ready for welding
(Ready* status). The handheld extrusion welder reaches its operating temperature after approx. 5 minutes.
In the event of a brief power supply interruption, it is not necessary to start a new start-up process.
Start-up delay: 30 seconds
Heating
Heat until
Motor blocked
2 , and it must be
Release M
Motor release
Ready*
Ready to weld
23