Service Menu - GPE Vendors DRX Manual Tecnico

CONNECTION OF THE PAYMENT SYSTEMS
A parallel coin mechanism can be connected to the 10 pin
connector CN6 or to the 16 pin connector CN5. These connectors
supply, respectively, a power supply of 12V and 24V to the coin
mechanism.
A parallel bill validator can be connected to the connector CN7
that can also supply a 12V power.
A serial payment system with Executive protocol can be connected
to connector CN8 or with MDB protocol to connector CN10.
The parallel coin mechanism and bill validator can be used
contemporaneously with the serial (Executive or MDB) payment
system.
VERIFYING AND MODIFYING OF THE WORKING PARAMETERS
To enter the service menu press the "service key" indicated in the
diagram for 1".
To return to the normal state of vending of the machine press
again this key or digit on the keypad "Esc" (9) and confi rm the
selection with the "OK" (8) key.
SET UP OF DEFAULT PARAMETERS
The board, for its functioning, avails of more 900 different
working parameters. Normally it is necessary to modify only
a few depending on specifi c needs. However, it is possible
to automatically re-install these parameters with the values
contained in 3 distinct default tables.
To set-up one of the default tables you must turn the machine on
whilst pushing down the "service key" and the key "1" or "2" or "3"
depending on the table.

SERVICE MENU

USE OF THE KEYPAD
All of the service and programming functions of the working
parameters are accessed through the use of the keypad of the
machine.
Keep the "Help" (3) key pressed down to visualize the current
functions of the keys in that particular menu or sub-menu:
The keys "1" and "2" allow the selection of one of the voices of the
menu.The "OK" (8) key confi rms the choice of the menu, whilst the
"Esc" (9) key is for exiting from the menu.
Once you have entered into a specifi c sub-menu of visualizing and
modifying of parameters the other keys come into use:
Keys "1" and "2" allow the selection of a specifi c parameter.
GB
35