Safety Instructions After Completing Work; Changing The Hedge Trimmer Angle; Basic Working Techniques - Husqvarna 325HE3 Manual De Instrucciones

• If any foreign object is hit or if vibrations occur stop the
machine immediately. Disconnect the HT lead from
the spark plug. Check that the machine is not
damaged. Repair any damage.
• If anything jams in the blades while you are working,
switch off the engine and wait until it has stopped
completely before cleaning the blades. Disconnect the
spark plug cap from the spark plug.
• Never put the machine down with the engine running
unless you have it in clear sight.

Safety instructions after completing work

• The transport guard should always be fitted to the
cutting attachment when the machine is not in use.
• Make sure the cutting attachment has stopped before
cleaning, carrying out repairs or an inspection.
Disconnect the spark plug cap from the spark plug.
• Always wear heavy-duty gloves when repairing the
cutting attachment. This is extremely sharp and can
easily cause cuts.
• Store the machine out of reach of children.
• Use only original spare parts for repairs.

Basic working techniques

• Work with a swinging action from the bottom upwards
when trimming sides.
• Adjust the throttle setting to suit the load.
• When trimming a hedge the engine should always
face away from the hedge.
16 – English
WORKING TECHNIQUES
• Hold the machine as close to your body as possible to
get the best balance.
• Make sure that the tip does not touch the ground.
• Do not rush the work, but work steadily until all the
branches have been cut back cleanly.

Changing the hedge trimmer angle

• Loosen the knob on the shaft (clockwise).
• Press the cutting unit against a firm surface until the
required angle is set.
• Turn the knob (anti-clockwise).
WARNING! Do not hold the cutting head
!
when you adjust the angle. The blades
are sharp and you could easily cut
yourself.
1157424-49 Rev.2 2019-11-30