Adjusting The Brakes - Manta MES001K Manual De Usuario

STOPPING/BRAKING
To brake, release the THROTTLE GRIP and depress the BRAKE LEVER (on the left side of
the handlebars. Depressing the brake will disengage power to the motor. When the unit
feels like it is loosing power or not accelerating to full speed, the scooter is ready to be re-
charged.
FOLDING & STORAGE
When you are done riding the scooter you can fold it down for compact storage and
transportation. To fold down the scooter, loosen the handlebar-folding clamp and gently
push down the folding handle. If needed, you may need to detach the left and right handle
grips and lower the T-handlebar prior to folding. See Assembly instructions.
BRAKING SYSTEM
The scooter uses a hub brake system on the rear wheel. A hand brake lever on the left side
of the handlebar activates the brakes. Squeezing the hand brake lever with your left hand
will activate the rear brake. Make sure to release the HAND THROTTLE GRIP when engaging
the brakes.
Practice braking on a smooth, dry surface to get used to the feel of the braking system.
Braking distance is affected by wet conditions and loose and uneven riding surfaces.

ADJUSTING THE BRAKES

The Brakes on the scooter should come fully adjusted from the factory.
However, it may be necessary to adjust the brakes from time to time.
For brakes that are adjusted too loose:
Tighten the tension screw on the left hand brake lever by rotating it clockwise until the
wheel has a slight drag.
For further adjustment, Locate the adjustment screw on the rear brake hub located on the
rear wheel.
MES001K – EN
13
To adjust the rear brakes:
For brakes that are adjusted
too tight:
Loosen the tension screw on
the left hand brake lever by
rotating it counter-clockwise
until the wheel spins freely.