Descargar Imprimir esta página

Ugin ARTIS NEO Modo De Empleo página 30

Ocultar thumbs Ver también para ARTIS NEO:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Instructions for use (rev 290319)
ARTIS NEO
5.9. Programming key
Use this key to initiate the programming mode.
After pressing
, you can enter or modify the firing parameters.
Once the program is entered, press
again to "confirm" the program settings.
5.10. VACUUM indicator
This indicator shows that the pump is in operation.
The pump continues to operate until the programmed vacuum level has been reached.
It is normal for the pump to stop and start several times during the firing cycle.
5.11. HEATING indicator
This indicator shows that the muffle is heating.
As the temperature rises, it goes on and off regularly as the muffle heats up at the programmed
rate.
UGIN DENTAIRE
28

Publicidad

loading

Productos relacionados para Ugin ARTIS NEO