Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
T
roubleshooting
Vacuum cleaner won't run
Possible causes
1.
Vacuum cleaner is not plugged in
2.
Power button is not pressed down
Vacuum cleaner won't pick up or low suction
Possible causes
1.
Tools, hose and/or telescoping extension wands are blocked
2.
Filters are dirty
3.
Dust bag is full
4.
Swivel hose not securely attached to suction opening
5.
Crack or hole in flex hose
6.
Air flow regulator or variable suction power
control is set to open or minimum setting
Visible dust escaping from vacuum
Possible causes
1.
Dust bag is full
2.
Filters missing or installed incorrectly
3.
Filters are dirty
4.
Flex hose is blocked
5.
Swivel hose not securely attached to suction opening
6.
Crack or hole in flex hose
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of
service. Contact us directly at 1-800-237-7691.
w w w . b i s s e l l . c o m
WARNING:
To reduce the risk of electric shock, turn
power OFF (
) and disconnect plug
from electrical outlet before performing
maintenance or troubleshooting.
Remedies
1. Check electrical plug
2. Press power button down
Remedies
1. Remove each part and check for blockages
2. Check and clean or replace pre-motor and post-motor filters
3. Replace with new dust bag
4. Make sure hose connector is locked into
suction opening
5. Check hose and replace if needed
6. Change to closed or maximum setting
Remedies
1. Replace with new dust bag
2. Check pre-motor and post-motor filter for correct installation
3. Check and clean or replace pre-motor and post-motor filters
4. Remove hose and check for blockages
5. Make sure swivel hose is locked into suction opening
6. Check hose and replace if needed
8 0 0 . 2 3 7 . 7 6 9 1
13
Publicidad
Tabla de contenido
Solución de problemas
