RECARO C 6000 Manual De Montaje página 48

L
2. Thread the EPS cable (1) from the installation kit through the panel (2) from the inside.
3. Push the cable grommet (3) into the panel (2).
M
4. Tightly screw the EPS 2 module in place with the 3 screws (4, 5) from the installation kit using the
stipulated torque (size 4 & 5 hexagon sockets).
Torque for screw in position 4:
Torque for screw in position 5:
5. Position the supplied cable tie (3)
6. Make the electrical connection (2).
7. Move the cable tie (3) that you fitted earlier onto the corrugated hose and then tighten it up.
8. Check the movement of the armrest and alter the length of the cable as necessary.
9. Fit the cover on the EPS module (1).
10. Tightly screw the right-hand seat panel in place with the screws (6) that you removed earlier using
the stipulated torque (T25 Torx adapter)
Torque:
Important note:
When carrying out any installation work, it is imperative that the stipulated torque is observed:
RECARO Automotive Seating
4.5 Nm ± 0.5 Nm
1 EPS cable
2 Seat panel
3 Cable grommet
1 EPS module cover
2 Electrical connection
3 Cable tie
4 M8 x 16 installation kit screws
5 M6 x 16 installation kit screws
25 Nm ± 2 Nm (size 5 hexagon socket)
15 Nm ± 2 Nm (size 4 hexagon socket)
Page 17