Cleaning; Maintenance - Skymsen SF-218 Manual De Instrucciones

the Blade cutting the product at constant speed.
After finishing the whole slice remove it with the right hand.
The slice shall ALWAYS be removed behind the Blade to
avoid the hand to contact the Blade
Place the slices upon the Fixed Table # 05 (Pic. 01).
Bring back the Movable Table to the front side of the
machine and repeat the above steps until to have finished
to cut all the product.
After the end of the last slice turn the ON/OFF Switch to the
position "O" (OFF) # 13 (Pic 01)

5. CLEANING

When the equipment must go through a complete cleaning
and sanitization process:
- Before to be used first time.
- After every day end of operations
- When the saw is not going to be used for a long period.
- Before to start operation after a long period it has not been
used.
Some components may be removed to clean:
- Door
- Fixed Table Block
- Blade
Follow below instructions to remove the above mentioned
components:
Door
Turn the two Door handle counterclockwise until they get
free from their screws. Open the Door #01 (Pic. 03), hold it
firmly and lift it.
Fixed Table Block
Remove the Fixed Table Block #01 (Pic. 04) just lifting it , see
picture 04.
4
Picture 03
01
Picture 04
Blade
Turn the Blade Tension Regulator Handle # 01 (Pic 05)
counter clockwise to get the Blade # 02 (Pic. 05) free to be
removed.
02
Blade Scraper
Once the blade is removed, Blade Scraper #01 (Pic.06) is
free to remove.
01
Use a clean cloth or a soft brush to remove residues.
Wash, sanitize, rinse and dry all the components.
Assemble back all the components following the inverse
path, and make sure all the components are correctly in
place.
Use Your QR Code Reader to access more
information regarding the cares needed
when handling stainless Steel.

6. MAINTENANCE

Maintenance must be considered a set of procedures
with the purpose to keep the equipment best operating
conditions, therefore increasing the equipment life and
safety.
Cleaning – check item 5 CLEANING
01
Wiring - Check all wires regarding deteriorate conditions as
well as all electric contacts (terminals) regarding tightening
and corrosion .
Contacts – ON/OFF switch, emergency button, reset button,
electronic circuits, etc., check the equipment in order to
assure that all components are correctly working and the
equipment operation is normal .
Installation – make sure the installation followed item 3
Picture 05
Picture 06
01