Problem Solutions - Skymsen SF-218 Manual De Instrucciones

instructions.
Life span: 2 years considering a normal working hours
journey
1 – Each month check:
- Check the electrical installation
- Measure the voltage at the socket
- Measure the working current and match it with the
nominal current
- Check the tightening of all electric terminals to avoid bad
contacts
- Check electric motor shaft clearance
- Check the wiring for overeating , insulation failures and

7. PROBLEM SOLUTIONS

PROBLEMS
- The equipment does not
switch on.
- Machine switch on but when
product touches the blade it
stops or runs slowly.
- Smoke or burn smell.
- Blade breaks frequently.
- Damaged Cord.
- Unusual noises.
- Difficulties to cut the product.
CAUSES
- Lack of Power;
- Problem with the internal or
external electric circuits.
- Belt slipping on pulleys.
- Damaged Motor.
- Problem with the internal or
external electric circuits.
- Dirty Blade or Wheel.
- Wheel Damaged.
- Problem during transportation.
- Problemas com rolamentos.
- Dirty blade or wheels.
- Blade with wrong tension;
- Blade is not on wheels center;
- Blunt blade.
mechanical damages.
2 Each three month checks
- Check electrical components such as ON/OFF switch,
emergency button , reset button, electronic electric circuits ,
overeating, insulation failings, or mechanical damages
- Check bearings clearances
- Check retainers, O'rings, V'rings and other seals
Use Your QR Code Reader to access
more information regarding safety and
maintenance.
- Check if there is electric power.
- Call Technical Assistance.
- Adjust the blade tension, see item 4.2.3;
- Call Technical Assistance.
- Call Technical Assistance.
- Clean,see the item 5 CLEANING.
- Call Technical Assistance.
- Call Technical Assistance.
- Call Technical Assistance.
- Clean, see the item 5 CLEANING;
- Adjust the blade tension, see item 4.2.3;
- Call Technical Assistance.
- Change the Blade.
SOLUTIONS
5