Features; Unpacking And Assembly; Technical Data - Surtek HL732 Manual De Usuario Y Garantía

11. ALWAYS wear protective clothing and safety
glasses. Loose particles and other debris may be
propelled at high speed by the water jet.
12. ALWAYS grip the gun firmly before pressing
the trigger, expect the gun to 'kick' when
starting.
13. ALWAYS respect the requirements of the
local water company. Power washers may only
be connected to the mains drinking water
supply, if a backflow preventer valve is installed
in the supply hose.
14.When not in use, ALWAYS disconnect from
the water supply, and ensure the system is
completely drained. Store in a cool dry location.
15. When using
facility, use only the chemical cleaning agents
(detergents), that are approved for power
washers or recommended by the dealer

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. GUN.
2. NOZZLE.
2
3. MOTOR.
4. WHEEL.
5. PUMP.
6. FRAME.
7. LANCE.
4

TECHNICAL DATA

HL732
VOLTAGE-FREQUENCY
MAXIMUM PRESSURE
MINIMUM FEEDING
MAXIMUM FLOW
POWER
WEIGHT
HL743
VOLTAGE-FREQUENCY
MAXIMUM PRESSURE
MINIMUM FEEDING
MAXIMUN FLOW
POWER
WEIGHT
14
the chemical injection
1
7
6
3
5
127 V ~ 60 Hz
11,03 MPa (1 850 PSI)
11 L/min
8,5 L/min
2 000 W
34.5 kg (76 lb)
220 V ~ 60 Hz
17,2 MPa (2 500 PSI)
12 L/min
9,5 L/min
3 200 W
46.46 kg (109,04 lb)

UNPACKING AND ASSEMBLY

UNPACKING
Unpack your power washer and check to ensure
the following items are present.
Contact your seller immediately if any parts are
missing or damaged.
• Hose, Gun/lance, Spray wand, Hook, Nozzle,
Double filter, Oil plug, Rubber feet, Fixings pack.
ASSEMBLY
CONNECTING THE WHEELS
1. Remove the nut, spring washer and washer
from the axle.
2. Fit the axles into the
axle ports as shown,
secure with the nut,
spring washer and
washer (Fig. 1).
3. Fit the wheels to the axles and secure with the
nut and washer.
ASSEMBLE THE LANCE
1. Connect the spray
wand to the lance and
tighten securely (Fig.3).
THE HIGH PRESSURE HOSE
CONNECT THE HOSE TO
THE GUN
1. Slide the connector
on the hose backwards
(Fig.4).
2. Push the gun into the
connector.
3. Release the connector.
NOTE: Mak e sure the connection is secure.
CONNECT THE HOSE TO THE WASHER
1. Slide the connector
on the power washer
towards the machine
(Fig.5).
2. Push the hose into
the connector.
3. Release the connector.
NOTE: Mak e sure the connection is secure.
INSTALL THE TOP FRAME
Position handle assembly
and main frame and
connect them with square
neck bolt, then fasten
with the knob. Repeat this procedure for the
opposite side.
Fig.1
Fig.3
Fig.4
i Fig.5