Surtek HL732 Manual De Usuario Y Garantía página 15

DOUBLE FILTER
Double filter can bet-
ter filter impurities and
waste inside the water,
it can help to protect
the pump and extend
the machine usage life.
Connect the double filter to the pump water
inlet connector, and then connect the garden
hose to the other end of double filter.
CONNECT WATER SOURCE
1. Connect the water
supply hose to the wa-
ter inlet (Fig.6).
NOTE: Water source
must provide a min
imum of 5 gallons per
minute at 20 PSI.
NOTE: Make sure the water supply hose is
screwed on tightly.
GUN/HOSE HOOK
1. Assemble the gun
hook into the position
shown and secure using
the washers and bolts.
BEFORE USE
WARNING: To carry out this check, place the
power washer on level ground with the motor
switched off.
WARNING: Take care not to touch any hot
parts of the power washer when checking the
oil levels.
IMPORTANT: The PUMP is supplied with oil
in it, unscrew the oil cap and install the pump
breather before use the machine. Fill the oil if
the oil capacity is not enough, see Below.
CHECKING THE PUMP OIL LEVEL
Look at the sight glass
on the pump to check
the oil level it should
be at the 1/2 position
of the sight glass If
required, remove the
oil filler cap and top up
with oil (Fig.8).
• Use SAE15W-40 oil, the oil capacity is 250 ml
for HL743 and 110 ml for HL732.
Fig.6
Fig.7
Fig.8
Oil filler cap
Sight glass Sight glass
Drain cap
E N G L I S H •
OPERATION INSTRUCTIONS
USING YOUR POWER WASHER
POWER WASHER TERMINOLOGY
Bypass mode: In bypass mode, the pump
recirculates the water because the trigger of the
spray gun is not being pulled. If unit is left in
bypass mode for more than two minutes, the
water temperature will rise to a dangerous level
and could damage internal components of the
pump.
NOTE: Any damage to pump due to these causes
will not be covered under warranty.
Easy start Valve: During pull starting, when
the engine is turned over pressure builds in the
system, the pressure in built in the system is a
tremendous load to attempt the engine starting
against. The easy start valve solves these issues,
it will dischage the water when pulling start to
help the engine to easy start, when squeeze the
trigger the valve will shut of, but it will dischage
the water when the system is in by pass. It is also
a features that use for sucking the water from
tank or pool. But it have to be connect the hose
that supply with.
STARTING THE POWER WASHER
Prior to starting, please check the electrial
supply voltage and the frequency correspond to
those specified on the applicance data plated.
Press "START" button to start the machine,
Press"STOP" to stop the machine.
1. Make sure the switch of the machine is in the
OFF position.
2. Check the mains power supply should
equipped with an adequate earth connection.
3. Make sure the power cord, hose, any
connector and gun is without any damaged.
4. Make sure that the filter screen is in water
inlet of pump. • Cone side faces out.
5. Turn water source on, and trigger on the gun
to relieve the pressure while starting.
NOTE: must point the gun to a safty direction.
WARNING: FAILURE TO TURN ON THE
WATER COULD CAUSE DAMAGE TO THE PUMP.
OPERATION THE UNIT WITHOUT WATER WILL
CAUSE SEALING WEARING OUT IN A MINUTER.
6. Insert the plug or switch the machine in the
ON position to start the machine. NOTE: If please
stop the motor immediately and check the the
electrial supply Voltage and the Frequency
correspond to data plated. the motor does not
start after after switched on, or the motor start
noisy.
U s er 's M an u al
15