Kingspan SENSiT Manual De Instalación página 3

5. WAVEGUIDE PIPE INSTALLATION (OPTIONAL)
• Choose a flat level point that is at the same
Outer Tank
level and no higher than any opening at the (Bund)
top of the tank (filling point etc)
• Only drill the tank where permissible
(Please consult the tank manufacturer
before drilling the tank)
Inner Tank
• Ensure that the unit is fitted to the inner tank
if it is a bunded tank
• The unit can't sit at an angle as this gives an
incorrect level. Take care not to choose an
area on which water could gather i.e. dent/
depression or a position directly above any
restricted area inside the tank.
• For tanks with window corrugations please
ensure that the transmitter is not positioned
above of the window.
Choose a suitable
Outer Tank
position for transmitter
Outlet Inner Tank
Sonic
Outer Tank
(Bund)
Inner Tank
30cm
Outer Tank
Tank Braces
(Bund)
Tank Windows
Inner Tank
Drill a hole in the place that you have selected on
the tank's top surface using a 58mm hole-saw.
(shown in Picture 15)
Warning: If you are unsure if you should drill the
tank please check with the tank manufacturer
first.
• Measure height from bottom of the tank to
Pic 11
the top of transmitter base
• Cut the pipe (maximum length of pipe 3m)
To obtain pipe length take 40mm off the
height from bottom of the tank to the top
of unit base
• Pipe type: ABS 32mm Waste Pipe, available
in your local DIY store
• Insert the pre-cut pipe to the pipe adapter
12 and screw the grub screws.
Pic
13
Pic
• Screw base to pre-drilled hole in the tank and
fit the unit.
• Ensure the unit is positioned vertical on top
of the tank and level. Ensure that the unit is
screwed correctly into the base and that the
threads have not crossed, to give a good seal
14
Pic
40mm
16
Pic
18
Pic
20
Pic
Pic 15
36.5 mm
58mm
17
Pic
19
Pic
21
Pic