Popp McSMOKE RF Instrucciones Para El Uso página 12

WHAT TO DO IF FIRE BREAKS OUT
1.
2.
3.
4.
5.
6.
Installation:
Important note:
In new buildings or renovated buildings, smoke alarms should not be installed until all work has been
completed (including the laying of floor coverings) and the building has been fully cleaned.
Installation, use, test and maintenance
Note:
Although the McSMOKE RF has a large range of 50m, concrete walls in a house can attenuate the
radio signal, and thus reduce the effective range. We recommend therefore that before proceeding
with the installation work each smoke alarm should always be tested in its intended location.
Insert the batteries into the radio module (3x AAA, 1.5V) and the smoke alarm (1x 9V block).
Connect the smoke alarm to the radio module. Make sure that the correct polarity is observed for the
connection.
Then connect the smoke alarm to the radio module.
P O P P G m b H • B a d B e r n e c k • G e r m a n y • w w w. p o p p - e l e k t r o . d e
McSmoke_RF.indd 12 McSmoke_RF.indd 12
Instruction Manual
Keep calm;
Leave the building immediately by the shortest route;
If there is thick smoke, keep close to the floor;
To prevent the fire spreading and to contain the smoke close all doors, but don't take risks;
Call the fire brigade (stating name, location of fire, possible injured persons)
Warn other occupants in the house. Give assistance to old people, the handicapped and children.
McSMOKE RF
18.10.2004 13:04:42 Uhr 18.10.2004 13:04:42 Uhr