Stainless Steel Surfaces; Light Bulbs; Warming Lamps - Monogram ZV36 El Manual Del Propietario

CARE AND CLEANING
STAINLESS STEEL SURFACES (on some models)
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.

LIGHT BULBS

To change the light bulbs:
1. Grasp the outer trim ring and twist until reaching the
unlock position. Then pull the ring straight out.
2. Grasp the bulb and twist until reaching the unlock
position. Then gently pull the bulb straight out.
3. Replace with the same wattage, type and size bulb.
Wear gloves. Do not touch bulb with your bare fingers.
These 120 volt, 50 watt halogen bulbs with a GU10
base are available at specialty lighting stores and home
building centers.
Order bulb no. WB08X10052.
4. Replace the outer trim ring by inserting the two retaining
tabs into the two tab slots, pressing the ring flush with
the surface of the hood insert and twisting until reaching
the lock position.

WARMING LAMPS

The warming lamps are located on the underside of the
hood.
These 120 volt, 175 watt, par 38 infrared heat lamp bulbs,
with standard base, are available at some specialty lighting
stores.
These infrared bulbs can also be ordered from your
Monogram supplier.
Order bulb no. WB08X10029.
49-2000857 Rev. 0
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer nearest
you, please call our toll-free number:
Monogram Preferred Service: 800.444.1845
Monogram.com
NOTE: If warming lamps are not desired, additional
cooktop lighting can be obtained by replacing the infrared
bulbs with standard incandescent bulbs with up to 100 watt
maximum ratings, with standard bases. These bulbs are
available at specialty lighting stores.
7