Basic Saw Operations; General Cutting; Circle Cutting - RIDGID BS1400 El Manual Del Propietario

Basic Saw Operations

General Cutting

CAUTION: For your safety, comply with all the
safety instructions on pages 2-4 before using the
band saw.
A band saw is basically a "curve cutting" machine. It is
not capable of doing inside cutting.
It is also used for straight-line cutting operations such as
crosscutting, ripping, mitering, beveling, compound cut-
ting and resawing.
This machine is fitted with a 3/8" x 93-1/2 bandsaw blade.

Circle Cutting

1. Adjust the upper guides to vertically just clear the
workpiece.
2. Use both hands while feeding the work into the blade.
Hold the workpiece firmly against the table. Use gentle
pressure, and do not force the work, but allow the
Blade Selection Guide for Minimum Circle Cutting
1/2"D 1"D 1-1/2"D 2"D
1/8" 3/16" 1/4"
Operation
Cross Cutting
Ripping
Mitering
Beveling
Compound Cutting
Circle Cutting
Resawing
Curve Cutting
NOTE: Blade length is 93-1/2"
blade to cut.
3. The smallest diameter that can be cut out is deter-
mined by the width of the blade. For example, a 1/4-
inch wide blade will cut a minimum diameter of approx-
imately 1-1/2-inch (see chart).
Circle Dia.
3/8"
Blade Size
24
Recommended Blade Width
(Inches)
1/4, 3/8, 1/2, 3/4
3/4
1/4, 3/8, 1/2, 3/4
1/4, 3/8, 1/2, 3/4
1/4, 3/8, 1/2, 3/4
See Chart Below
3/4
1/8, 1/4
4"D 7"D
1/2" 3/4"