directly at the light sources! Risk group 1 as per
EN 62471. Danger value in case of exposure (EHV):
2200 seconds in 800 mm. The free group limit
values are complied with at a distance of 1.8 m.
Retinal danger due to actinic light 400 nm to
780 nm.
•
Protect your bright field magnifier from knocks,
strikes, moisture, and excessive heat. Never place
your bright field magnifier on a heating element
or in direct sunlight. Use of the storage pocket
supplied is recommended.
•
Batteries must not be disposed of in household
waste. Make sure that they are correctly disposed
of.
•
The product is a Class I medical device (non-sterile,
without measuring function) and complies with
Regulation (EU) 2017/745. For use of the product
outside the EU member states, the respective
country-specific directives must be observed.
Use
Place the brightfield magnifier [1] with the even, flat side on
the reading material so that the product is slightly inclined
towards you.
Switch the lamp on by pressing the button [2]. Pressing the
button again will switch off the lamp. The lamp will switch
off automatically after 30 minutes to conserve battery
power. If you still require the lamp, you can simply switch it
back on.
Now adjust the distance between eye and reading material,
until you see a sharp image. Use the most comfortable
distance between your eye and bright field magnifier. It is
dependent on the reading glasses being used and your eyes'
adaptability.
Switch off the lamp when done.
Changing batteries
Switch off the lamp.
Open the battery case [3] by sliding it up and taking it off
the bright field magnifier.
Now remove the exhausted batteries and insert new batter-
ies as shown in the diagram.
- 8 -