Wiring - Craftmade Dalton DAL48 A Guía De Instalación Para El Usuario

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab.
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury or
death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will
be necessary to use a heavy duty wood screw,
washer and lock washer (not supplied) with the
safety cable loop. If necessary, adjust the loop at the
end of the safety cable. The loop at the end of the
safety cable should just fit over the threads on the
wood screw. Test safety cable by pulling on loose end
of safety cable with pliers. If the safety cable slips, the
loop must be adjusted smaller. Extra cable slack can
be left in ceiling area.

6. Wiring.

WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
Note: Excess lead wire length from the fan can
be cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, electrical wiring can be made as
follows:
Connect BLUE wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling
with wire connector provided.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
wood
ceiling
joist
white supply wire
black supply wire
from ceiling
black
white
white
blue
from fan
(wiring for fan)
page 6
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot
motor housing
ground
(green or bare)
ground (green
or bare)
*