ADIC SNC 4000 Manual Del Usuario página 104

SNC4000 > icmpstatShow
ICMP:
0 call to icmp_error
0 error not generated because old message was icmp
0 message with bad code fields
0 message < minimum length
0 bad checksum
0 message with bad length
0 message response generated
value = 30 = 0x1e
ifShow
El comando ifShow se usa para mostrar tanto los parámetros del puerto de Ethernet como el estado, como
se muestra abajo. El SNC 4000 mostrará dos dispositivos. ibmEmac es el puerto de Ethernet. lo es el
puerto loopback local.
SNC4000 > ifShow
ibmEmac (unit number 0):
Flags: (0x8063) UP BROADCAST MULTICAST ARP RUNNING
Type: ETHERNET_CSMACD
Internet address: 172.16.38.48
Broadcast address: 172.16.255.255
Netmask 0xffff0000 Subnetmask 0xffff0000
Ethernet address is 00:00:60:00:00:00
Metric is 0
Maximum Transfer Unit size is 1500
0 octets received
0 octets sent
2354 packets received
2 packets sent
2354 unicast packets received
1 unicast packets sent
0 non-unicast packets received
1 non-unicast packets sent
0 input discards
0 input unknown protocols
0 input errors
102 output errors
0 collisions; 0 dropped
lo (unit number 0):
Flags: (0x8069) UP LOOPBACK MULTICAST ARP RUNNING
Type: SOFTWARE_LOOPBACK
Internet address: 127.0.0.1
Netmask 0xff000000 Subnetmask 0xff000000
Metric is 0
Maximum Transfer Unit size is 32768
0 packets received; 0 packets sent
0 multicast packets received
0 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
value = 29 = 0x1d
98 Referencia del comando del puerto de servicio