Setup And Transport - LORCH S Pulse XT Manual De Instrucciones

10

Setup and transport

Danger of injury due to the device falling
down or tipping over.
When transporting using mechanical lifting
equipment (e.g. crane, etc.), only the hoisting
points shown here may be used. Use suitable
load-bearing equipment.
Do not use a fork-lift truck or similar device to
lift the machine by its housing.
Lifting point for 4-point hoisting of the S
movable
Fig. 3: Hoisting points
- 42 -
maximum
15°
909.2599.9-06
Setup and transport
Remove the gas cylinder from the welding ma-
chine before transportation .
Handle 14 serves only for transport by one per-
son.
The machine must be transported or set up
only on firm, level surfaces. The maximum ad-
missible angle of inclination for setting up or
transporting is 10°.
maximum
15°
Attachment points for 2-point
hoisting for additional case
Lifting point for 1-point hoisting of the
S mobile
14
01.21