Miniland chefy 6 Manual Del Usuario página 22

ENGLISH
4. Press the defrosting/temperature maintenance button (C). The screen (A) will show the value '37'
by default.
5. The device will start the defrosting process after a few seconds.
PRECAUTION: The defrosting process will continue until you switch the appliance off. To obtain an
optimum result, we recommend continuously removing the content and checking its status whilst it
is defrosting.
6. For frozen milk, consult the table of estimated freezing times.
7. Once defrosted, follow the steps in section 5.2 HEATING BOTTLES OR JARS OF BABY FOOD to
heat the bottle or jar. Consider an initial temperature of 20ºC.
Volume in the bottle
120ml
180ml
240ml
NOTE: These times have been estimated to reach a temperature of approximately 20ºC. Different
types, forms and sizes of bottles or jars will result in changes to the defrosting times.
5.7 TROUBLESHOOTING
SYMPTOMS
The unit will not switch on
The screen is switched off
The heating plate has white spots
and/or the cover is peeling
The screen is flashing and emitting
an alarm
The appliance has a reduced
heating efficiency
The equipment works but is not
heating
Other incorrect operations
6. MAINTENANCE
6.1. CLEANING
Follow the instructions indicated below:
1. Always switch off the device and unplug it before cleaning it.
2. Remove any remaining water from the deposit (3).
3. Use a damp cloth to clean the appliance.
4. Do not submerge or use water or other liquids to clean the electrical unit (1), the cable or the mains
plug (5).
5. Use a soft cloth to clean the screen (A).
6. The basket (8), sterilisation base (10), lid (6) and the sterilisation cover (11) can be cleaned perfectly
in the dishwasher or with hot water and soap.
Defrosting time
40 min
50 min
70 min
POSSIBLE CAUSES AND CORRECTIVE ACTIONS
Check that the apparatus is plugged into the mains.
Check that electricity is supplying the plug.
If the appliance is connected to a multi-socket adaptor,
check that this is switched on.
Connect the appliance to another plug.
Check that the appliance is plugged in and press the on
button.
The accumulation of limescale is normal, particularly in
hard water areas. Remember to clean the unit regularly, as
indicated in section 6.
There is not enough water in the heating plate. Replace it
and restart the process.
Check for a build-up of limescale on the deposit plate.
Clean the plate by following the instructions in point 6 until it
returns to its normal function.
Contact Miniland's technical service.
22