Status Of Led - Runtal 40016512 Manual De Instrucciones

Resetting the time and the day:
To reset the time and the day:
 Check the remote control is turned on.
 Go to settings by holding down P1P2 and mode simultaneously.
 Set the time and the date, press mode to go to the End screen, then press mode again to
confirm and exit.
Pairing  essential procedure when you first turn the appliance on!
Make sure you only pair one appliance and one remote control at a time.
LED:
To ensure the LED can be seen properly, you can pair your appliance before
fitting it on the wall, or else use a small mirror.
The first time the appliance is turned on, the LED turns on as a steady magenta
light, to show that pairing has not yet been done (see chapter 4.2).
CLIC
Procedure using the unit on the back of your appliance:
WARNING!
You must always first activate the pairing function on the appliance itself, before
activating it on the remote control.
1) Press on the LED once, on the back of the appliance.
Wait until the LED stops flashing magenta and changes colour.
2) Press again on the LED on the back of the appliance.
The LED flashes magenta again. You then have one minute to pair your appliance with the
remote control.
52
WARNING
The appearance of the
LED may vary according
to the appliance model
(see cover page 3).
40016512
Pairing (cont)

Press for 5
seconds
on the +
boost
key.
mode

boost
mode
If pairing fails, the display
on the control goes back to rF 0.
You can then try pairing again by pressing
the + key for 5 seconds (check first that the
appliance is still ready to pair:
the LED is flashing magenta).
If pairing still does not work,
4.2 Status of LED (on radiator or towel dryer)
STATUS
Fixed
COLOUR
Eco mode
Green
Comfort mode
Red
Frost-free mode /
Blue
Load shedding (pilot wire)
T° override°
Yellow
Pairing error /
Magenta
Appliance not paired
11/2017

It searches
for the
appliance
for a few
boost
seconds.
mode

boost
mode
contact your dealer.
Flashing
Boost
• Standby
• Powered down
Open window
• Stop (pilot wire)
detected
• Stop load
shedding (pilot
Error
wire)
Pairing underway

boost
mode

boost
mode
Off
53