Advanced Parameter Setting For Remote Control - Runtal 40016512 Manual De Instrucciones

5.5 Advanced parameter setting for remote control

WARNING!
Access to parameter setting is possible only when the remote control is off.
Some parameters on your remote control can be adjusted according to how you use it.
2
seconds
boost
mode
Parameter
number
boost
Back to
previous
mode
parameter.
No Parameter Description
0
Duration Adjustable from 15 to 120 minutes in 15 minute steps
of Boost
operation
1 Window Value 0 (function disabled) or 1 (function enabled)
open
detection
2
Eco Value 0 (eco temperature unlinked) or 1 (eco temperature
temperature linked)
64
Press on P1P2 and
mode for 2 seconds
to enter.
Parameter
value
WARNING
It is essential to get
to the final "End" screen,
to confirm your parameter
Go to
changes.
the next
parameter.
Default Setting
setting
60 Press the
1
Press the
1 Press the
No Parameter
3
Pilot wire
4 Ambient
temperature
calibration
5
None
boost
mode
6 None
7
Re-pairing
radio-
frequency
!
8 Default
display
9
Display
version
number and
reset (unpai-
ring).
+ -
or key
End Display para-
meter setting
+ -
or key
output
+ -
or key
After no key has been pressed for one minute, the remote control will automatically
quit the advanced parameters and turn off.
40016512 11/2017
Description
Value 0 (pilot wire disabled) or 1 (pilot wire enabled)
Adjustable from -5.0°C to 5.0°C in 0.5°C steps
Value 0 (unpaired command) or 1 (paired command)
Value 0 (time) or 1 (temperature setting)
Back to factory settings
Warning!
All your settings as well as the pairing, will be deleted.
Quit the settings menu
Default Setting
setting
+ -
1 Press the or key
+ -
0.0
Press the or key
--
--
Press on + or - key to
rF0 ou rF1
re-pair an appliance
which was previously
paired but has lost the
link.
+ -
1
Press the or key
Press on + key for 10
x.xx
seconds to reset.
Short press on
mode or for 2 seconds
on .
65