Control Panel - Monitor Audio PLW215 II Guía De Configuración Inicial

Control Panel

3
4
5
1. Main Indicator LED's
These LED's show the levels and the presets selected depending on the mode being adjusted. It will by default show the
trim volume level.
In normal operation, the volume trim level will be displayed along with the Level LED (2) and numbered preset LED 1-4 (3)
will be illuminated.
2. Trim Level Indicator
When just turning the control dial, the trim level is the default mode. This can be adjusted +/- 11 dB and does not adjust the
master volume control. This must be set by the SubConnect application.
3. Numbered LED's
These are the 4 presets. Only the selected preset will be illuminated and remain illuminated whilst the preset is in use.
4. Preset Select.
By pressing down on the control dial repeatidly to illuminate the Preset LED, the preset selection mode is activated. Turn the
dial to select the required preset. By default EQ profiles for each of the presets are: Music (1), Movie (2), Flat (3) and Impact
(4). When adjusting the presets, the 7 Indicator LED's around that preset will be illuminated
5. Phase Adjustment.
Press down on the control dial repeatidly to illuminate the Phase LED. The phase is adjusted in 15 degree increments with
the main LED's illuminating to show the phase angle.
6. Crossover Adjustment
Press down on the control dial to illuminate the Crossover LED. Here you adjust the LPF crossover frequency (when using the
stereo inputs). This is adjusted in 5Hz steps from 20 to 135 Hz and is preset to 80Hz.
7. Control Dial
Use this to adjust the trim level (just turn the dial) or select from the crossover selection, phase or presets by pressing the
dial until the required feature is illuminated.
1
2
monitoraudio.com
7
6
5