Kohler K-11830 Guia De Instalacion página 7

Control Box
Screws
6. Install the Supplies
NOTE: Do not connect the control box wiring in this step.
Remove the control box cover. Make sure to keep the screws and
cover.
Mark the location of the screws using the control box as a
template. Make sure the wire harness hole in the wall is covered
by the box.
Install appropriate wall anchors (not provided) at the marks.
Feed the wires through the back of the valve and control box.
Attach the valve and control box to the wall with two screws (not
provided).
Kohler Co. 7 1080064-2-A