Kohler STERLING 4700 Serie Guía De Instalación Y Cuidado página 13

Outside Panel
Hanger Bracket
Bolt
Hanger
Bracket
Roller
Bushing
Steel
Side
8. Install the Rollers
Install the Hanger Bracket
Insert a bushing into one of the holes at the top of the glass panels.
Install a hanger bracket over the glass panel, aligning the hole in the bracket with the bushing.
Insert a bolt through the hanger bracket hole and bushing. Secure with a blind nut.
Repeat the above steps to install the remaining three hanger brackets.
NOTE: The steel side of the roller must be installed against the hanger bracket.
Install the Outside Panel Rollers
IMPORTANT! If the glass panels have a textured side, install both rollers on the textured side of the
panel. If the glass panels are smooth on both sides, make sure that both rollers are installed on the same
side of the panel.
Assemble the rollers and #8-32 x 3/8" screws through the center hole of each hanger bracket.
Install the Inside Panel Rollers
IMPORTANT! If the glass panels have a textured side, install both rollers on the smooth side of the panel.
If the glass panels are smooth on both sides, make sure that both rollers are installed on the same side of
the panel.
Assemble the rollers and #8-32 x 3/8" screws through the center hole of each hanger bracket.
Sterling
Blind
Nut
#8-32 x 3/8"
Screw
Roller
Inside Panel
Bolt
Hanger
Bracket
Roller
Steel
Side
13
Hanger Bracket
Blind Nut
#8-32 x 3/8"
Screw
Bushing
Roller
1054388-2-D