Publicidad
Idiomas disponibles
Idiomas disponibles
Prior to assembly of HD Roller, be sure that your base rails are properly
installed and square with each other.
Measure diagonally across the rails. Measurements "X" & "Y" should be within
3/16" of each other. These measurements are required for proper fit and
function of the Husky HD Roller.
Install the Husky Center Bolt kit using the parts provided in this kit.
1.
Locate the center hole in each base rail. See Figure 1. Using these holes
as a guide, drill a 5/8" hole through the truck bed. BE SURE THERE ARE
NOT ANY FUEL TANKS, FUEL OR BRAKE LINES OR ANY other
obstructions below the bed BEFORE drilling.
2.
Drop the 5/8 carriage bolts supplied through the center bolt locations,
through the truck bed.
3.
Check the corrugations in the truck bed floor and place the spacer plate in
the correct position as shown. Tighten the 5/8" carriage bolts to 150 ft. lbs.
Base
Rail
Bed
Corrugation
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information / Tech Support / Product Updates.
2020 Keystone Automotive Operations Inc. All Rights Reserved. 12/07/2020-Rev3
X
Figure 1
Y
Figure 2
Center Bolt hole
locations
Carriage
Bolts
Spacer
Plates
Page-4
Publicidad
