Safety Decals - Allmand MAXI-LITE Manual Del Operario

WARNING
Entanglement / Sever Hazard
• Always stop the engine before beginning service.
• If the engine must be serviced while it is operating,
remove all jewelry, tie back long hair and keep hands,
other body parts and clothing away from moving/
rotating parts.
• Verify that all guards and covers are attached properly
to the equipment before starting the engine. Do not
start the engine if any guards or covers are not properly
installed on the equipment.
• Attach a "Do Not Operate" tag near the key switch while
performing maintenance on the equipment.
WARNING
Flying Object Hazard
• Always wear eye protection when cleaning the
equipment with compressed air or high pressure water.
Dust, flying debris, compressed air, pressurized water
or steam may injure your eyes.
WARNING
Coolant Hazard
• Wear eye protection and rubber gloves when handling
engine coolant. If contact with the eyes or skin should
occur, flush eyes and wash immediately with clean
water.
WARNING
Burn Hazard
• Opening cap on hot radiator could result in death
or serious injury. Allow radiator to cool down before
opening cap.
WARNING
Burn Hazard
• Light fixtures and some of the engine surfaces become
very hot during operation and shortly after shutdown.
• Keep hands and other body parts away from hot
surfaces.
• Handle hot components, such as light fixtures, with heat
resistant gloves.
4
NOTICE
• Any part which is found defective as a result of
inspection or any part whose measured value does not
satisfy the standard or limit MUST be replaced.
• Always tighten components to the specified torque.
Loose parts can cause equipment damage or cause it
to operate improperly.
• Follow the guidelines of the Environmental Protection
Agency (EPA), Environment Canada (EC) or other
governmental agencies for the proper disposal of
hazardous materials such as engine oil, diesel fuel and
engine coolant.
• Only use replacement parts specified. Other
replacement parts may effect warranty coverage.
• Clean all accumulated dirt and debris away from the
body of the equipment and its components before
you inspect the equipment or perform preventative
maintenance procedures or repairs. Operating
equipment with accumulated dirt and debris will cause
premature wear of equipment components.
• Never dispose of hazardous materials by dumping them
into a sewer, on the ground, or into groundwater or
waterways.
• Retrieve any tools or parts that may have dropped
inside of the equipment to avoid improper equipment
operation.
• If any alert indicator illuminates during equipment
operation, stop the engine immediately. Determine
the cause and repair the problem before continuing to
operate the equipment.

Safety Decals

Before operating your unit, read and understand the following
safety decals. The cautions, warnings, and instructions are for
your safety. To avoid personal injury or damage to the unit,
understand and follow all the decals.
Keep the decals from becoming dirty or torn, and replace
them if they are lost or damaged. Also, if a part needs to be
replaced that has a decal attached to it, make sure to order
the new part and decal at the same time.
If any safety or instructional decals become worn or
damaged, and cannot be read, order replacement decals
from your dealer.
US Models
DANGER - Entering electrical
compartment while equipment is in
operation will result in death or serious
injury. Shut down equipment before
entering electrical compartment.
Part No. 107251