Publicidad
Idiomas disponibles
Idiomas disponibles
WHERE TO INSTALL THE APPLIANCE
Place the purifier on a flat, stable surface in the room requiring treatment.
To allow the air to circulate freely, avoid placing the appliance behind curtains, below a window, item, furniture,
or shelf unit, or close to any other obstacle, and leave at least 50 cm of free space on each side of the appliance.
Recommended to be used in ambient conditions lower than 35°C 70%RH (95°F).
BEFORE USING THE APPLIANCE FOR THE FIRST TIME
Make sure that the plastic packaging protecting the filters has been removed before using the appliance.
Before the first use, ensure the voltage, frequency and power of your appliance suit your electric supply.
Your appliance can operate using an ungrounded plug. It is a class II (double electrical insulation
Before switching on your appliance, ensure that:
- the appliance is completely assembled as described in the safety instructions,
- the appliance is placed on a stable, horizontal surface,
- the appliance is positioned in accordance with the instructions given in this manual,
- the air inlets and the oultet grid are completely unobstructed,
- the filters and panel have been correctly installed (See section "Disassembling / Reassembling filters")
IMPORTANT: You are advised to switch off and unplug the appliance when not in use.
OPERATION
• Power button (1)
– Press this button to turn the air purifier on/off.
• Mode button (2)
– AUTODAY and AUTONIGHT mode: if the air quality level is excellent then the device does not run.
– Press this button to select one of the four modes. The corresponding indicator will turn on to indicate the
selected mode.
– Daytime auto mode: the fan speed is set to 1,2,3 or 4.
– Nighttime auto mode: The fan speed is set to 1 or 2.
– Quiet mode: The fan speed is set to minimum. Use this mode in quiet environments.
– Turbo mode: The fan speed is set to maximum. Use this mode when air quality is poor.
• Child lock (3)
– The lock system prevents the purifier from being accidentally mis-set during operation.
– To activate it, press the button (3) for 3 sec until the locked control panel indicator turns on. To exit this mode,
press the button (3) again for 3 seconds, until the indicator turns off. When selected, the other buttons are
locked.
• Wi-Fi button (4)
– Frequency band operated : 2400-2483.50 MHz
– Maximum radio-frequency power : 20 dbm
– To turn on or off the Wi-Fi function on your purifier, simultaneously hold the Wi-Fi button
lock button
for 3 seconds.
– When the Wi-Fi connection indicator
• Reset (5)
– By pressing together the MODE
– First, the appliance will make a BIP to indicate Reset is launched. Then, the appliance should erase all pairing
data.
– Once done, the product will make one long BIP.
– To finish unplug the product for at least 10 secs.
PLUG/UNPLUG
– Once the product is unplugged, wait for at least 10 secs before plugging it back.
8
flashes it means that the purifier lost its connection.
and WIFI
button for 5 seconds.
).
and the child
Publicidad
