Operation Of The Basic Functions; Quick Access; Changing A Quick Access - DURAVIT D.1e D11100008010 Manual De Instrucciones

5. Operation of the basic functions

The tap unit is operated through the control unit. The settings are
EN
also made through the control unit.
Press and hold the control unit to make the settings, always on
the basis that the tap unit is inactive (no water flow).
Turn the water on:
> Press 1x
Turn the water off:
> Press 1x
Adjust the temperature:
> Rotate
Rotate when the water is flowing.
Adjust the temperature
using the light ring
(blue = cold, red = hot)

5.1 Quick Access

The following three settings are factory settings and can be
adjusted individually:
Quick Access 1
Press 1x: Water is
ON at 20 °C

5.2 Changing a Quick Access

Proceed as follows to change a Quick Access:
> Choose the Quick Access to be changed (1, 2 or 3).
> Rotate to the desired temperature.
> Press and hold until the light ring lights up VIOLET. Release the
button immediately.
The light ring flashes VIOLET twice, the water is OFF and the
settings are saved.
The Quick Access cannot be set to higher than 38 °C (scald
protection).
24
Quick Access 2
Press 2x: Water is
ON at 30 °C
Quick Access 3
Press 3x: Water is
ON at 35 °C