Instalación De Los Módulos En El Dt-900; Connecting Wires - Promax DT-800 Manual De Usuario

CONTROL MODULE. DT-800
3.2 Instalación de los módulos en el DT-900.
To install a module in the subrack, you should slide the module into the subrack,
screwing it to the frontal guide (Fig. 4).
In order to get a tidy installation of the modules you should follow the next
advises:
•
Place the DT-800 at the left end of the sub-rack.
•
Place the DT-700 and / or DT-710 at the right end of the sub-rack.
•
Place the DT-101/102 and the DT-301/302 side by side in the case they were
paired.
•
Place the rest of the modules together, without leaving a gap between them.
Figure 4.- Installation of the modules into the sub-rack.
Following these advises you will achieve a tidy installation and the best
configuration for later maintenance or new modules addition.

3.3 Connecting wires

The modular composition of the DTTV headend makes it flexible to adapt it to
customer needs. The DT-800 control module is able to control up to 7 modules.
04-2012 Page 7