Password - Promax DT-800 Manual De Usuario

If any of the modules is not listed or its status is not OK, check the connections,
especially the control and power cord, which is what connects the control unit with the
modules, and by which is transmitted the power supply and the identification data and
settings.
If the problem persists, adjust the settings or contact our customer service.
If you want to pass to the setup menu, enter the password and press ENTER
.
The system has a "TIME OUT", which makes the screen again, after a certain
time without touching any keys.

4.6 PASSWORD

Access to the configuration of the equipment is protected by a password
(PASSWORD) to prevent improper access by unauthorized persons.
After starting up and scanning, press ENTER
order to get into the PASSWORD screen.
The default password is "2008".
To enter the password follow the steps below to EDIT a NUMERIC value. You
can apply these steps in order to edit any numeric value.
1.- Press ENTER
2.- Press RIGHT
units to thousands.
Page 16
Figure 11.- Password.
to get into the PASSWORD option.
or LEFT to move among the numbers, from
CONTROL MODULE. DT-800
key from the frontal equipad in
04-2012