Chevrolet Performance 84099784 Manual Del Usuario página 6

• Remove Air Cleaner Assembly (1) from engine bay (box supported in 3 rubber grommets). Caution: Rubber grommets
on bottom of air box may pop out during removal. Be careful not to lose them as they will be used with the performance
air induction system air box.
• Thoroughly clean Air Box Assembly Inlet Mating Duct Surface (vehicle side rubber duct behind driver's side headlight)
with recommended surface primer (Not included in kit). AC Delco Surface Primer GM P/N 12378462 (OR) 3M 94 Primer.
Allow time to dry.
• Remove MAF Sensor from production Air Cleaner Assembly by loosening MAF screws (2 - T20 screws). Ensure that
the MAF Sensor Sealing Gasket stays on MAF Sensor Body to be installed into Performance Air Induction System MAF
Housing.
Chevrolet Performance Air Induction Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Chevrolet Performance Air Induction Kit Install
REV 22FE17
26SE16
22FE17
84099784
PART NO.
DATE
Initial Release - Benjamin Kaminsky
Revision - Benjamin Kaminsky
6
SHEET
REVISION
36
OF
AUTH
2545956
2642462