Decoder Installation - Marklin Digital 60948 Manual Del Usario

• Acceleration and braking delay can be set separately
from each other. Any function button desired can be as-
signed using the function mapping.
• Typical sound backdrops for diesel and electric locomo-
tives are included.
• Variable motor feedback control is available in digital as
well as in analog operation.
• 6090, 60901, DC, and can motors with bell-shaped arma-
tures are supported.
• Function mapping included.
• Can be updated with the CS2 (Software 2.0, track format
processor GFP 2.0 or higher).
• Programming on the Main (PoM) this type of program-
ming must be supported by the controller. Please note the
instructions for your controller when doing this.
• Switching range can be set.
• Braking / signal stopping block recognition is available in
digital operation.

Decoder Installation

The locomotive must be checked before installing the de-
coder to make sure that it (locomotive) is in good mechanical
and electrical condition. There are situations when the loco-
motive will have to be repaired before installing the decoder.
Remove the body and pull the flexible ribbon cables for the
lights from their connectors. Loosen the four screws for the
circuit board.
Example: It's possible that there may be differences from
model to model.
27