Nogueira PN-MASTER 3000 Manual De Instrucciones página 11

Rack (3)
If the rack (3) is disassembled, assemble it
according next steps:
a) Assemble the rubber cushion (3a) according
detail below, using the bolts (3b) + plain washer
+ spring washer + nut.
b) Assemble the rails (3c) on illustrated position
below, using a bolt on each side (3d) + two plain
washers + one nut.
c) Install the spindles (3e) according the picture,
using three nuts (3f) on rear part.
NOTE: All the bolts, nuts and washers used in
that assembly which follow the machine.
Installing the Forage Chopper and motor on
the rack
3
Install the Forage Chopper on the rack (3) and
fasten it with four bolts (4a) + plain washers and
the nuts.
3b
3a
PN-MASTER 3000
3d
3e
4a
3c
3f
two nuts from
the outside
3
11