Gap Adjustments Between Knife And Counter Knife - Nogueira PN-MASTER 3000 Manual De Instrucciones

Gap adjustments between knife and counter knife

This adjustment must be done after the
5
sharpen or new knifes installation.
3
a) Remove the feeding chute (1) loosing the pin
(2).
b) Loosen (but don't remove) the impeller
fastening bolts (3).
c) Displace the impeller (4) manually forward,
4
approximating the knifes (5) nearest as possible
against the counter knife (6).
IMPORTANT: It cannot have interference
7
between the knives and counter-knife during the
operation. Therefore, Nogueira recommends a
minimum gap 0,05 to 0,15 mm.
d) Check the gap through feeding nozzle (7),
6
turning the impeller (4) manually and slowly.
1
2
8
e) After the adjustment, tighten the bolts (3) to
fasten the impeller (4) on correct position.
f) Reinstall the chute (1) and close the impeller
compartment cover.
18
Instructions manual