Jump-N-Carry JNC345 Manual Del Operador página 5

Jump Starter Specifications
Battery Type:
Battery Capacity:
Operating Temperature:
Charging Temperature:
Recharge Input:
USB Output:
Jump Starting Output:
DC Pin Output:
Power Indicator:
Safety Features:
Approvals:
UNIT STATUS AND RECHARGING PROCEDURES
Note: Upon initial purchase, your Jump Starter should be charged for a minimum of 6
hours. The Jump Starter should be charged every three months when not in use.
Unit Status Indication
Press the Status/Power Button on the front of the unit to power the battery status LEDs
and see the unit's state of charge. The unit's state of charge status is indicated by the
number of status LEDs lit: 1 LED - 25%; 2 LEDs – 50%; 3 LEDs – 75%; 4 LEDs – at
or near 100%.
– If the unit has below 75% state of charge, it should be charged soon.
– If the unit has below 50% state of charge, it should be charged immediately.
It is recommended that the unit be at or near 100% state of charge when using as a
jump starter. This will greatly improve your jump starting success.
Recharging Your Jump Starter
WARNING: Never use a charger other than the one that was included with your unit.
Using an incompatible charger could damage the internal battery, which could result in
property damage or injury.
WARNING: When charging the internal battery, work in a well ventilated area and do
not restrict ventilation in any way.
1. Connect the pin jack at the end of the included AC adapter cord to the jump
starter through the input port marked "DC Input."
2. Connect the male end of the AC adapter to the AC outlet.
3. Using this method, the unit will be brought to full charge automatically without
overcharging.
Lithium Ion
14.8V/79Wh
-22˚F - 140˚F
40˚F - 110˚F
18V 2A Adapter (Pin Jack)
5V 2.4A x 2 (Max 4A total)
14.8VDC/79Wh
14.8V 10A
LED Display
Built-in
TUV (Conforms to UL2743)
5