Jump-N-Carry JNC345 Manual Del Operador página 6

OPERATING INSTRUCTIONS
Used as a USB Power Supply
Your jump starter can be used to power or recharge a wide variety of small electronic
devices.
1. Connect your device's charging cable to the device.
2. Connect the USB end of the charging cable into the USB port on the jump starter.
3. Press the Status/Power Button on the front of the unit to activate USB charging.
Used as a DC Power Supply
Your unit can be used to power a variety of DC accessories using the included DC
Female Adapter. Please note that the typical output voltage of this port is 15VDC
(nominal, 14.8V actual), which is similar to the voltage seen from a vehicle's power port
when the vehicle is running.
1. Connect the male plug from your DC powered device to the DC Female Adapter.
2. Connect the pin jack at the end of the DC Female Adapter cord to the output port
marked "15V10A Output".
Used as a Flashlight
WARNING: Avoid direct exposure of LED light to eyes. Do not shine into the eyes of
people or animals. Keep away from children.
To turn on the LED Flashlight, press and release the light button. Successive pushes of
the button will change the light pattern from solid to strobe to SOS to off.
Used as a 12 Volt Jump Starter
Note: For optimum performance, do not store your Jump Starter below 50°F when using
as a jump starter. Never charge or jump start a frozen battery.
Note: When using as a jump starter, it is recommended that the unit be at or near 100%
state of charge as indicated on the unit's display.
DANGER: Never use an output cable/clamp assembly other than the one that was
included with your unit. The use of another cable/clamp assembly could result in personal
injury and/or property damage.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eye wear when working near batteries.
3. Review this instruction manual and the instruction/safety manual provided by the
manufacturer of the vehicle being jump started.
4. Connect output cables/clamps to the jump starter through the covered jump
starting port. Be sure that the cable connection is fully engaged and secure.
6