EN
NOTE! Petrol is perishable and should
not remain in the tank for more than 30
days
It is possible to use ecological fuels, i.e. alkylate
petrol. The composition of these petrols is less
harmful to people and the environment.
No negative effects linked to use of the same
have been reported. However, there are types
of alkylate-based petrol available on the market
for which it is not possible to give precise indica-
tions regarding their use.
For further information it is advisable to consult the
instructions and data provided by the producer of
the alkylate-based petrol.
Never fill the tank right to the top.
Leave a little space (equal to at least the whole
depth of the top-up mouth + 1 - 2 cm from the top
of the tank) so that when the petrol heats up it has
room to expand without overflowing.
If you plan on putting the machine away
for a prolonged period (e g over the
winter), only put enough fuel in the tank
to finish the last job in hand.
In fact, before storing the machine it is
a good idea to empty the fuel tank com-
pletely (see 10)
7 4
CHECKING THE ENGINE OIL LEVEL
(18; 19; 19A)
The machine is delivered complete with engine oil.
Before starting the machine check the
level of the engine oil
To check / top up the engine oil, see
9 5 1
7 5
SAFETY CHECKS
When trying out the machine, check that the
results of the safety checks correspond with the
indications provided in the following tables.
Always carry out the safety checks be-
fore use
If any of the results fails to match the
indications provided in the following ta-
ble, do not use the machine!
Take it to a service centre to be checked
and repaired if necessary
16
ENGLISH
(Translation of the Original Instructions)
7 5 1 General safety check
Object
Fuel lines and
connections.
Electrical cables
Exhaust system.
Oil lines
Drive the ma-
chine forwards/
backwards and
release the driving
pedal.
Test driving
7 5 2 Electrical safety check
Status
The clutch-brake
pedal is not pres-
sed.
The PTO is not
activated.
The gear selector
is not in neutral
position
The PTO is acti-
vated..
Engine switched
on. The PTO is
activated.
Engine switched
on. The PTO is
activated
Engine switched
on.
7 6
START-UP / OPERATION
When using the machine, the bonnet
must be closed and fastened shut
Always use full throttle when using the
machine
When starting the machine, wait for
2 seconds in starting position before
starting the engine
Result
No leaks.
All insulation intact.
No mechanical damage.
No leaks at connections. All
screws tightened.
No leaks. No damage.
The machine will stop.
No abnormal vibrations.
No abnormal sound.
Action
Result
The engine
Try to start
does not
the machine.
start.
Try to start
The engine
the machine.
will not start.
The driver
The engine
gets off the
will not start.
seat
The driver
The engine
gets off the
will not start.
seat
Remove the
The engine
20A fuse
stops
(1:L).